|
|
|
|
|
IETF RFC 4136
OSPF Refresh and Flooding Reduction in Stable Topologies
Last modified on Thursday, July 28th, 2005
Permanent link to RFC 4136
Search GitHub Wiki for RFC 4136
Show other RFCs mentioning RFC 4136
Network Working Group P. Pillay-Esnault
Request for Comments: 4136 Cisco Systems
Category: Informational July 2005
OSPF Refresh and Flooding Reduction in Stable Topologies
Status of This Memo
This memo provides information for the Internet community. It does
not specify an Internet standard of any kind. Distribution of this
memo is unlimited.
Copyright Notice
Copyright © The Internet Society (2005).
Abstract
This document describes an extension to the OSPF protocol to reduce
periodic flooding of Link State Advertisements (LSAs) in stable
topologies.
Current OSPF behavior requires that all LSAs, except DoNotAge LSAs,
to be refreshed every 30 minutes. This document proposes to
generalize the use of DoNotAge LSAs in order to reduce protocol
traffic in stable topologies.
1. Introduction
The explosive growth of IP-based networks has placed focus on the
scalability of Interior Gateway Protocols such as OSPF. Networks
using OSPF are growing every day and will continue to expand to
accommodate the demand for connections to the Internet or intranets.
Internet Service Providers and users that have large networks have
noticed non-negligible protocol traffic, even when their network
topologies were stable.
OSPF requires every LSA to be refreshed every 1800 seconds or else
they will expire when they reach 3600 seconds [1].
This document proposes to overcome the LSA expiration by generalizing
the use of DoNotAge LSAs. This technique will facilitate OSPF
scaling by reducing OSPF traffic overhead in stable topologies.
Pillay-Esnault Informational PAGE 1
RFC 4136 OSPF Refresh and Flooding Reduction July 2005
2. Changes in the Existing Implementation
This enhancement relies on the implementation of the DoNotAge bit and
the Indication-LSA. The details of the implementation of the
DoNotAge bit and the Indication-LSA are specified in "Extending OSPF
to Support Demand Circuits" [2].
Flooding-reduction-capable routers will continue to send hellos to
their neighbors and keep aging their self-originated LSAs in their
database. However, these routers will flood their self-originated
LSAs with the DoNotAge bit set. Thus, self-originated LSAs do not
have to be re-flooded every 30 minutes and the re-flooding interval
can be extended to the configured forced-flooding interval. As in
normal OSPF operation, any change in the contents of the LSA will
cause a reoriginated LSA to be flooded with the DoNotAge bit set.
This will reduce protocol traffic overhead while allowing changes to
be flooded immediately.
Flooding-reduction-capable routers will flood received non-self-
originated LSAs with the DoNotAge bit set on all normal or flooding-
reduction-only interfaces within the LSA's flooding scope. If an
interface is configured as both flooding-reduction-capable and
Demand-Circuit, then the flooding is done if and only if the contents
of the LSA have changed. This allows LSA flooding for unchanged LSAs
to be periodically forced by the originating router.
3. Backward Compatibility
Routers supporting the demand circuit extensions [2] will be able to
correctly process DoNotAge LSAs flooded by routers supporting the
flooding reduction capability described herein. These routers will
also suppress flooding DoNotAge LSAs on interfaces configured as
demand circuits. However, they will also flood DoNotAge LSAs on
interfaces that are not configured as demand circuits.
When there are routers in the OSPF routing domain, stub area, or NSSA
area, that do not support the demand circuit extensions [2] then the
use of these flooding reduction capabilities will be subject to the
demand circuit interoperability constraints articulated in section
2.5 of "Extending OSPF to Support Demand Circuits" [2]. This implies
that detection of an LSA, with the DC bit clear, will result in the
re-origination of self-originated DoNotAge LSAs with the DoNotAge
clear and purging of non-self-originated DoNotAge LSAs.
Pillay-Esnault Informational PAGE 2
RFC 4136 OSPF Refresh and Flooding Reduction July 2005
4. Security Considerations
This memo does not create any new security issues for the OSPF
protocol. Security considerations for the base OSPF protocol are
covered in [1].
5. Acknowledgments
The author would like to thank Jean-Michel Esnault, Barry Friedman,
Thomas Kramer, Acee Lindem, Peter Psenak, Henk Smit, and Alex Zinin
for their helpful comments on this work.
6. Normative References
[1] Moy, J., "OSPF Version 2", STD 54, RFC 2328, April 1998.
[2] Moy, J., "Extending OSPF to Support Demand Circuits", RFC 1793,
April 1995.
Pillay-Esnault Informational PAGE 3
RFC 4136 OSPF Refresh and Flooding Reduction July 2005
A. Configurable Parameters
This memo defines new configuration parameters for the flooding
reduction feature. The feature must be enabled by configuration on a
router and is, by default, off.
flooding-reduction <all | list of interfaces> Indicates that the
router has the flooding reduction feature enabled. By default,
this parameter applies to all interfaces running under the OSPF
instance to which it applies. The feature can be enabled on a
subset of explicitly specified interfaces.
flooding-interval <n minutes> Indicates the interval in minutes for
the periodic flooding of self-originated LSAs. By default, this
value is 30 minutes as per [1]. The minimum value is also 30
minutes. A value of infinity will prevent re-flooding of self-
originated LSAs that have not changed.
Author's Address
Padma Pillay-Esnault
Cisco Systems
170 W. Tasman Drive
San Jose, CA 95134
EMail: ppe@cisco.com
Pillay-Esnault Informational PAGE 4
RFC 4136 OSPF Refresh and Flooding Reduction July 2005
Full Copyright Statement
Copyright © The Internet Society (2005).
This document is subject to the rights, licenses and restrictions
contained in BCP 78, and except as set forth therein, the authors
retain all their rights.
This document and the information contained herein are provided on an
"AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS
OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY AND THE INTERNET
ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED,
INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE
INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED
WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
Intellectual Property
The IETF takes no position regarding the validity or scope of any
Intellectual Property Rights or other rights that might be claimed to
pertain to the implementation or use of the technology described in
this document or the extent to which any license under such rights
might or might not be available; nor does it represent that it has
made any independent effort to identify any such rights. Information
on the procedures with respect to rights in RFC documents can be
found in BCP 78 and BCP 79.
Copies of IPR disclosures made to the IETF Secretariat and any
assurances of licenses to be made available, or the result of an
attempt made to obtain a general license or permission for the use of
such proprietary rights by implementers or users of this
specification can be obtained from the IETF on-line IPR repository at
http://www.ietf.org/ipr.
The IETF invites any interested party to bring to its attention any
copyrights, patents or patent applications, or other proprietary
rights that may cover technology that may be required to implement
this standard. Please address the information to the IETF at ietf-
ipr@ietf.org.
Acknowledgement
Funding for the RFC Editor function is currently provided by the
Internet Society.
Pillay-Esnault Informational PAGE 5
OSPF Refresh and Flooding Reduction in Stable Topologies
RFC TOTAL SIZE: 8534 bytes
PUBLICATION DATE: Thursday, July 28th, 2005
LEGAL RIGHTS: The IETF Trust (see BCP 78)
|